VASCO (801) 692-7924 Get a quote
VASCO
Call (801) 692-7924

Shelving and racking installation crews for retail rollouts.

We assemble steel shelving, racking and store fixtures to the plan, by the bay, inside the hours the building allows. Our crews have built Metalsistem systems for a national grocery chain and travel from Utah for multi-site programs. That adds up to more than 3,400 new bays at 22 sites in 17 states so far.

Metalsistem systemsNight installs17 states so far
Run of steel shelving bays with yellow dividers, installer checking the far end of the aisle
Systems
Boltless shelving, racking, gondola, fixtures
Where
22 sites in 17 states
Closeout
Level check, anchor check, photos per bay run
Utah contractor license
B100 #12546496-5501

The same sequence on every bay

A shelving run is a repeatable build. Layout lines first, then uprights and bracing, beams, shelves and dividers, then anchors and a level check before the next bay starts.

We staff a lead who reads the fixture plan and installers who have built the system before. On a rollout that means site four goes up the way site one did.

  • Layout snapped from the fixture plan before a single upright stands
  • Beam and shelf heights set to the plan, checked with a tape on every bay
  • Anchoring per the manufacturer and the stamped drawings where they apply
  • Packaging broken down and staged for removal as we go
3 bays, one run

Installed by our crews

Fulfillment halls, stock rooms and back-of-house runs. Photos from our own installs in Texas, Utah, Indiana, Idaho, Florida, Nevada, Iowa and Virginia.

Every install on our records, site by site

Completed installs from our job records, with the count of new bays at each site. Extensions and reconfigurations at the same sites are not counted.

Washington: Federal Way 146 baysWAIdaho: Nampa 99 baysIDNew York: Corfu 120 baysNYNevada: North Las Vegas 115 bays, Reno 66 baysNVIowa: Council Bluffs 113 baysIAIndiana: Whitestown 300 baysINPennsylvania: Imperial 121 baysPACalifornia: Fresno 116 bays, Simi Valley 7 baysCAUtah: Salt Lake City 461 baysUTColorado: Loveland 117 baysCOVirginia: Rockville 115 bays, Hampton 6 baysVAArizona: Mesa 249 baysAZNorth Carolina: Wilmington 117 baysNCSouth Carolina: Summerville 18 baysSCAlabama: Loxley 102 baysALTexas: San Antonio 723 bays, Houston 136 baysTXFlorida: Jacksonville 165 bays, Daytona Beach 31 baysFL
Sites
22
States
17
New bays
3,443
Site cityNew baysWhen
San Antonio, TX723August 2026
Salt Lake City, UT461July 2026
Whitestown, IN300September 2026
Mesa, AZ249September 2026
Jacksonville, FL165February 2026
Federal Way, WA146July 2026
Houston, TX136October 2025
Imperial, PA121January 2026
Corfu, NY120February 2026
Loveland, CO117June 2026
Wilmington, NC117June 2026
Fresno, CA116October 2026
Rockville, VA115August 2026
North Las Vegas, NV115July 2026
Council Bluffs, IA113October 2025
Loxley, AL102May 2026
Nampa, ID99October 2025
Reno, NV66February 2026
Daytona Beach, FL31September 2026
Summerville, SC18December 2025
Simi Valley, CA7November 2025
Hampton, VA6January 2026

Counts are new bays per site from our job records. Sites are listed by city, without client or site names. The biggest local install is in Salt Lake City.

Systems and fixtures we install

Boltless steel shelving

Metalsistem Super 1-2-3 style hook-in shelving with solid or wire decks, dividers, mesh backs and bin fronts.

Grocery and fulfillment shelving

Pick shelving with dividers for micro-fulfillment and back-of-house grocery, set to a planogram.

Pallet and wide-span racking

Selective pallet rack and wide-span runs, anchored and plumbed, with engineering coordinated when height requires it.

Gondola and store fixtures

Sales-floor gondola, wall systems, end caps and specialty fixtures from the fixture package.

Mezzanine and multi-tier

Shelving-supported mezzanines and multi-tier systems, installed with the manufacturer's drawings and a licensed engineer's stamp.

Reconfigure and decommission

Add bays, change shelf heights, relocate a run, or take a system down, label it and palletize it.

Supply and install can be one conversation

VASCO shares ownership with Metalsistem USA, which supplies Metalsistem's Italian-engineered storage systems in the United States. If you are still specifying, the product and the install can be quoted together. The people laying out the run talk to the people who will build it.

If your fixtures come from another manufacturer or a fixture house, we install those too. Send the plan set and the bill of materials.

Metalsistem installation

Freestanding steel shelving bays assembled in a back-of-house stock room

Built for store hours and landlord rules

Live stores and malls decide when a crew can work. We schedule overnight and early-morning shifts, submit after-hours requests and certificates ahead of time, check in with security, and clear equipment before the doors open.

Each shift ends with photos of what was built and a short note on what is next, sent to your project manager.

  • Certificates issued per landlord with additional insured and waiver of subrogation endorsements
  • Hard hats, hi-vis and site-specific safety rules followed
  • Freight received, counted and staged against the bill of materials
  • Punch list walked with the store or general contractor before we leave
Installer in a hard hat and hi-vis vest checking upright height with a tape measure

Permits and engineering for racks in Utah

Rack permits are an easy step to miss. These are the thresholds Utah cities generally apply. Your city's building and fire officials make the call.

Rack or storage heightWhat generally appliesWhat we do
Up to 5 ft 9 inUsually exempt from a building permitInstall to the manufacturer's instructions
Over 5 ft 9 inBuilding permitIdentify the requirement and assemble the submittal
8 ft and tallerStamped structural drawings with seismic anchorage designCoordinate drawings with a Utah-licensed engineer and anchor to them
Storage above 12 ftFire code review for high-piled storageFlag it early so sprinklers and aisles are checked before install

Electrical work on or for racks needs its own permit and is performed by a licensed electrician.

Working outside Utah

16 of the 17 states in our install log are outside Utah. Licensing, registration and permit rules for fixture and rack installation vary by state and city.

We confirm what applies before we mobilize. On some projects we install under the project's general contractor or the equipment supplier. General contracting and tenant improvement services are offered in Utah, under Utah B100 #12546496-5501.

VASCO install crew setting shelf levels in a stock room

From plan set to handover

  1. Send the plan and bay count

    Fixture plan, bill of materials, site address, working hours and target dates. We reply with questions within one business day.

  2. Crew and schedule

    You get a written quote with crew size, shifts and travel stated. For multi-site work we quote the program and the per-site rate.

  3. Receive and stage

    We receive freight, count it against the bill of materials, and report shortages and damage the same day.

  4. Build by the bay

    Layout, uprights, beams, shelves, accessories, anchors. Photos at the end of every shift.

  5. Punch and handover

    Level and anchor check, punch walk with your representative, and closeout photos of every run.

FAQ

Questions we get on the first call

Do you travel for shelving and racking installs?

Yes. Our crews are based in Lehi, Utah and have installed in 17 states. Travel, lodging and shift plans are stated in the quote as their own lines.

Which shelving systems do you install?

Metalsistem boltless steel shelving is the system we know best. We also install gondola, store fixtures and other manufacturers' shelving from your plan set and bill of materials. Pallet rack and multi-tier systems are quoted case by case.

Can you supply the shelving as well as install it?

Yes. Our sister company, Metalsistem USA, distributes Metalsistem storage systems in the United States, so product and installation can be quoted together.

Do my racks need a permit?

Often, yes. In Utah, racks over 5 ft 9 in generally need a building permit. Racks 8 ft and taller generally need stamped structural drawings with seismic anchorage. Storage above 12 ft can trigger fire review for high-piled storage. Your city decides, and we identify what applies before install.

Are you licensed in every state you work in?

No, and you should be wary of an installer who claims that. We hold a Utah B100 general contractor license. Outside Utah we provide installation crews, confirm each state's requirements before mobilizing, and install under the project's general contractor or supplier where that is required.

Can you install overnight in an operating store?

Yes. Night and early-morning shifts are normal for us. We handle the landlord's after-hours paperwork and clear tools and packaging before the store opens.

What do you need to quote an install?

The fixture plan or bay count, the system and manufacturer, site address, working hours, and target dates. Photos of the space help.

Send the plan set and the bay count.

We reply within one business day with questions, then a written quote with crew, shifts and travel spelled out.